1648 Main Street Cardiff, MD 21160 USA
Collector Cars/Street Rods For Sale
 All steel original body, 4-dr sedan. Body and frame have been sandblasted. Frame is painted black and body is primed. Installed is a rebuilt small block Chevy engine, with auto trans, both from a 1977 Camaro, with an S-10 Blazer rear end. The front straight axle has been reworked and I installed spindles from a '53 Chevy with hydraulic brake drums and shoes. Steering wheel and column are from 1977 Camaro. Also have power steering rack. However, steering linkage from rack to wheels and steering column needs to be installed and hooked up. The front end has been lowered and the rear end has lowering blocks, but the rear really needs one or two leaf springs removed to really lower it correctly. (Rear springs are heavy duty) The engine has been completely rebuilt including: main bearings, new cam shaft, bearings, and lifters. New rings, valves and seats have been done. New timing chain and gears. New fuel pump, water pump, starter and rebuilt carburetor. I did all that and installed motor, trans, drive shaft and rear end, but never wired up the motor, so I ve never heard the motor run. I squirt oil in the spark plug holes every once in a while and turn it over with a remote starter switch and battery. I have the original glass for it, including windshield. The entire interior wood frame was replaced with oak by the previous owner. It has no interior. I have the front seat metal frame and the rear seat wooden frame. The floor needs metal to be installed. The center piece of the roof has been replaced with oak strips and plywood and is ready for padding and black vinyl covering. I have all interior inner door frames with window mechanisms and door and window cranks. I have brand new outside door handles. I have the original radiator and grill shell and hood. I have (from previous owner) brand new galvanized metal running boards and aprons that fit from bottom of doors to running boards. I also have new black rubber material, for top of running boards. I also have the front apron (goes between the front fenders, below the radiator shell. I have tried to list everything here, but I am sure I missed something. A lot has been done, but a lot is left to do. What it needs for completion is: Complete wiring, gauges, steering hooked up, metal floor installed, complete interior, body work, paint, vinyl roof installed, glass installed, etc. I am getting ready to retire to Florida and thought about transporting the car to Florida and finish it there. However, if I can sell it here, I will do that. I can use the cash. Price: I am asking $4,500. Vehicle is located in Massachusetts, near the NH border. I have Massachusetts Title for this vehicle. Information Email: jimmymerrick64@hotmail.com |
|
 BACK |  HOME |